Ricoh AP2610N - Manual (Page 405)

Message List
115
7
Exit pserver (In print server mode) Exits the print server
because the necessary print server settings
have not been made.
Frametype =<frame type name> The <frame type name> is configured to be
used on NetWare.
httpd start. An httpd has started.
IEEE 802.11b current channel <Channel> The current channel is displayed.
The value chosen by the user is displayed in ad
hoc mode.
The channel used in the access point is dis-
played in infrastructure mode.
(Example: Current channel is 11.)
IEEE 802.11b current channel 11
IEEE 802.11b MAC Address = <MAC Ad-
dress> The IEEE 802.11b I/F MAC address is dis-
played.
(Example: Current MAC address is
00:00:74:XX:XX:XX.)
IEEE 802.11b MAC Address =
00:00:74:XX:XX:XX
IEEE 802.11b SSID <ssid> (AP MAC Address
< MAC Address>) The SSID of the access point used in infrastruc-
ture mode and the MAC address of the access
point are displayed.
(Example: Current MAC address is
xx:xx:xx:xx:xx:xx and SSID value is "test-ssid".)
IEEE 802.11b SSID test-ssid (AP MAC Address
xx:xx:xx:xx:xx:xx)
IEEE 802.11b Tx Rate <Transfer Speed> The IEEE 802.11b transmitting speed (set
speed) is displayed.
(Example: Current Tx Rate is 11Mbps.)
IEEE 802.11b Tx Rate 11Mbps
inetd start. An inetd has started.
<interface> started with IP: <IP address> <IP address> has been set for <Interface> and
<Interface> started.
<Interface>: Subnet overlap. Subnet from Netmask and the IP address you
tried to set for <Interface> overlap the subnet
for another interface.
Set Subnet so that it does not overlap with an-
other interface.
IPP cancel-job: permission denied. The printer could not authenticate the name of
the user attempting to cancel a job.
ipp disable. Printing with ipp is disabled.
ipp enable. Printing with ipp is enabled.
Message Description and Solutions