configuring the printer for the network, Ethernet configuration, Configuring the printer for the network – Ricoh AP2610N User Manual
Page 55
41
3. Configuring the Printer for
the Network
Make the network settings below depending on the network interface you use.
• Parallel/USB: Making network settings is not necessary. Go to p.51 “Install-
ing the Printer Driver and Software”.
• Ethernet: Make the settings in p.41 “Ethernet Configuration”, and then see
p.51 “Installing the Printer Driver and Software”.
• IEEE 1394: Make the settings in p.45 “IEEE 1394 Configuration”, and then see
p.51 “Installing the Printer Driver and Software”.
• Wireless LAN: Make the settings in p.48 “IEEE 802.11b (Wireless LAN) Con-
figuration”, and then see p.51 “Installing the Printer Driver and Software”.
Note
❒ The optional Network Interface Board is necessary to use Ethernet with Basic
model printer.
❒ The optional 1394 Interface Unit is necessary to use IEEE 1394.
❒ The optional 802.11b Interface Unit is necessary to use the wireless LAN.
Ethernet Configuration
Configure the printer for the network
using the printer's control panel.
The following table shows the control
panel settings and their default val-
ues. These items are included in the
”Host Interface” menu.
Reference
For information about configuring
the computer for the network, see
the Network Printing Guide on the
CD-ROM labeled “Operating In-
structions”.
For information about “Host Inter-
face” menu, see “Host Interface
Menu” in the Printer Reference on
the CD-ROM labeled “Operating
Instructions”.
*1
❍ means that this protocol is active.
*2
Make this setting only when it is nec-
essary.
*3
Appears only when both the Network
Interface Board and the 802.11b Inter-
face Unit are installed.
Setting Name
Value
IP Address
011.022.033.044
Subnet Mask
000.000.000.000
Gateway Address
000.000.000.000
Network Boot
None
Frame Type (NW)
(Frame type NetWare)
Auto
Active Protocol
TCP/IP
NetWare
NetBEUI
AppleTalk
Auto
Ethernet