Ricoh AP2610N - Manual (Page 85)

Installing the Printer Driver Using IEEE 1394
71
4
Printing with IP over 1394
You can print by setting the IP address for this machine and the computer on
which Windows XP is installed.
Preparation
"IP over 1394" must be set on the control panel and an IP address for the IEEE
1394 must be specified.
For more information about how to make printer settings, see p.45 “IEEE 1394
Configuration”.
Limitation
❒ When using the IEEE 1394 (IP over 1394) interface in a network, the Ethernet
interface cannot be used in the same network.
Note
❒ The maximum number of simultaneous print requests when connecting with
IP over 1394 includes the print requests from the Ethernet interface. For more
information, see the Network Printing Guide.
Installing the Printer Driver
To Print using Standard TCP/IP port. For more information about Standard
TCP/IP port settings, see Network Printing Guide.
- - - -Inactivating the Device
❖ ❖ ❖ ❖ When [Add New Hardware Wizard] starts every time you restart the computer with
an operating system, which does not support SCSI print or plug in or out the cable,
inactivate the device by following procedures.
• Windows Me
A In the [Add New Hardware Wizard] dialog box, confirm that [Windows has
found the following new Hardware: IEEE SBP-2 Device]
is displayed, and se-
lect [Recommended search for a better driver [Recommended]], and then click
[Next>]
.
B When the [Windows was unable to locate the software for this device.] mes-
sage appears, click [Finish].