Ricoh AP2610N - Manual (Page 300)

Windows 95/98/Me Configuration
10
1
Setting Up a Client Computer
This section describes the procedures for setting up a client on a network that
uses Windows 2000, Windows XP, Windows NT Server or Windows NT Work-
station as a print server.
When using a Windows 2000, Windows XP or Windows NT print server, select
a shared printer on Windows 2000, Windows XP or Windows NT.
Limitation
❒ When using a print server connected to the printer with SmartNetMonitor for
Client, you cannot use Recovery Printing and Parallel Printing.
Note
❒ This section assumes that the client has already been configured to communi-
cate with a Windows 2000, Windows XP or Windows NT print server. Do not
begin the following procedure until the client has been set up and configured
correctly.
AAAA
Install the printer driver as a local printer.
Reference
For more information about installing the printer driver, see the Setup
Guide.
Note
❒ Any port can be selected during the installation, however, LPT1 is recom-
mended.
BBBB
Click [Start], point to [Settings], and then click [Printers].
CCCC
Click the icon of the printer you want to use. On the [File] menu, click [Prop-
erties]
.
Windows 2000, Windows XP or
Windows NT Print Server
Windows 95/98/Me