Ricoh AP2610N - Manual (Page 412)

Appendix
122
7
Configuring a WINS Server
The printer can be configured to register its NetBIOS name with a WINS server
when power is turned on. This enables the NetBIOS name of the printer to be
specified from SmartNetMonitor for Admin even under a DHCP environment.
This section describes how to configure the WINS server.
Note
❒ The WINS Server is supported with Windows NT 4.0 Server Service Pack 4 or
later, and Windows 2000 Servers WINS Manager.
❒ For more information about the WINS Server settings, see Windows Help.
❒ If there is no reply from the WINS Server, the NetBIOS name will be regis-
tered by broadcast.
❒ The NetBIOS name consists of up to 13 alphanumeric characters.
Using a WWW browser
AAAA
Start the Web browser.
BBBB
Point your browser at the URL or IP address of the printer (e.g. ht-
tp://XXX.XXX.XXX.XXX where the Xs are the number of the IP address).
The status of the printer you chose appears on the Web browser.
CCCC
Click Network Config.
The dialog box for entering the password and user name is displayed.
DDDD
Enter your user name and password, and then click OK.
To use the factory default account, enter no user name and type "password"
for the password.
EEEE
Click TCP/IP.
FFFF
Set WINS to active and enter the IP address of the WINS server in Primary
WINS Server and Secondary WINS Server.
GGGG
Click Refresh.
HHHH
Exit the Web browser.