Ricoh AP2610N - Manual (Page 236)

Making Printer Settings with the Control Panel
134
6
*1 Appears only when the 1394 Interface Unit board is installed.
*2 Appears only when the 802.11b Interface Unit board is installed.
*3 While the printer is Online, press
{{{{Enter #}}}}, and then press {{{{Escape}}}}. Finally, press
{{{{Menu}}}} . You can access the "USB Setting" menu on the panel display.
IEEE 802.11b *2 You can make settings for using the wireless LAN. This menu ap-
pears only when the optional IEEE 802.11b board is installed.
❖ ❖ ❖ ❖ Comm.Mode
You can set the transmission mode for IEEE 802.11b.
Note
❒ Default: Ad hoc
❖ ❖ ❖ ❖ Channel
The selectable channels are 1-11 (Inch version) and 1-13 (Met-
ric version).
Note
❒ Default: 11
❖ ❖ ❖ ❖ Trans. Speed
You can set the transmission speed for IEEE 802.11b.
Note
❒ Default: Auto
❖ ❖ ❖ ❖ WEP Settings
You can set the code for IEEE 802.11b.
Note
❒ Default: Not Active
❒ You need to set the WEP code key from the network before
making this setting. Without the key, transmission cannot
be performed.
❒ Be sure to set the key before setting the code to "Active".
USB Setting *3 You can set the transmission speed for USB.
Note
❒ Default: Auto
Menu Description