Ricoh AP2610N - Manual (Page 333)

Using SmartNetMonitor for Client
43
4
CCCC
After the confirmation message appears, click [Yes].
UninstallShield removes all of the components of SmartNetMonitor for Cli-
ent.
DDDD
After a confirmation message appears, click [Yes].
EEEE
Acknowledge the [Remove Shared File?] dialog box.
FFFF
When the uninstallation is complete, click [OK].
Setting Up the Printer Driver
The following procedure allows you to configure the printer port to use Smart-
NetMonitor for Client.
Preparation
The target printer must be turned on before starting the installation process.
AAAA
Install the printer driver of the printer you want to use.
BBBB
From the [Printers] window, click the icon of the printer. On the [File] menu,
click [Properties].
CCCC
Click the [Ports] tab and click [Add Port].
DDDD
Click [SmartNetMonitor] from the list, and then click [New Port...].
The [Select Printer] dialog box appears .
The displayed items are as follows:
Model Name: The model name of the printer.
Name: The name of the Network Interface Board.
Comment: Additional information about the Network Interface Board.
Address: The IP address of the printer.
EEEE
Select the printer.
TCP/IP
A Click the printer you want to use, and then click [OK].
Note
❒ Printers that respond to an IP broadcast from the computer will be dis-
played. To print to a printer not listed here, click [Specify Address], and
then type the IP address or host name.