Configuring the protocols, Configuring tcp/ip and ipp for printing, 2configuring the protocols – Ricoh AP2610N User Manual

Page 305

Advertising
background image

Configuring the Protocols

15

2

Configuring the Protocols

Configuring TCP/IP and IPP for Printing

Follow these instructions to configure the Network Interface Board and Win-
dows 2000 to use the TCP/IP protocol and IPP.

Configuring the machine

Configure the machine to use the TCP/IP protocol.
• Make sure that the TCP/IP protocol is set to active. (The default is active.)
• Assign an IP address and make other settings required for using the TCP/IP

protocol.

Reference

For more information about how to make the above settings, see the Setup
Guide.
If DHCP is used to assign IP addresses, see p.121 “Using DHCP”.

Note

❒ After setting the IP address, use the ping command to make sure that it has

been set correctly.

A

Click [Start], point to [Programs], point to [Accessories], and then click [Com-
mand Prompt]

.

B

Type the following: (Example IP address is 192.168.15.16)
C:\> ping 192.168.15.16
If the address has been configured correctly, the following message ap-
pears.
Reply from 192.168.15.16 : bytes=32 time<10ms TTL=32
If the address has been configured incorrectly, the following message ap-
pears.
Request timed out.

Configuring a Windows 2000 computer

Follow these steps to configure a Windows 2000 computer to use the TCP/IP
protocol.

AAAA

Click [Start] on the taskbar, point to [Settings], and then click [Network and
Dial-up Connections]

.

BBBB

Click [Local Area Connection]. On the [General] tab, click [Properties].

Advertising