Ricoh AP2610N - Manual (Page 59)

IEEE 1394 Configuration
45
3
IEEE 1394 Configuration
Use this procedure to configure the
printer for use in the IEEE 1394 envi-
ronment. The following table shows
the control panel settings and their
default values. These items are in-
cluded in the "Host Interface" menu.
Depending on the protocol you use,
procedures vary. See the following ta-
ble.
AAAA
Press
{{{{Menu}}}}.
“Menu” appears on the panel dis-
play.
BBBB
Press
{{{{U U U U}}}} or {{{{T T T T}}}} to display “Host
Interface” menu.
CCCC
Press
{{{{Enter #}}}}.
The following message appears on
the panel display.
DDDD
Press
{{{{U U U U}}}} or {{{{T T T T}}}} to display “IEEE
1394 Setup”.
EEEE
Press
{{{{Enter #}}}}.
The following message appears on
the panel display.
FFFF
Press
{{{{U U U U}}}} or {{{{T T T T}}}} to display “IP
over 1394”.
A Press {{{{Enter #}}}}.
B Press {{{{U
U U U}}}} or {{{{T T T T}}}} to select ei-
ther "Active" or "Not Active".
C Press {{{{Enter #}}}}.
The display returns to the previ-
ous menu in a few seconds.
Setting Name Value
IP Address1394 000.000.000.000
Subnet Mask1394 000.000.000.000
IP over 1394 Active
SCSI print Active
Bidi-SCSI print Active
IP over 1394 Steps
A-H and then
go to steps M to N
SCSI print Steps A-D and then
go to steps I to N
Menu:
Host Interface
Enter Form Feed
Job Reset
On Line
Escape
Menu
Power Error Data In
ZFDP020N
Host Interface:
I/O Buffer
Host Interface:
IEEE 1394 Setup
IEEE 1394 Setup:
IP Address1394
IEEE 1394 Setup:
IP over 1394
Enter Form Feed
Job Reset
On Line
Escape
Menu
Power Error Data In
ZFDP060N