Ricoh AP2610N - Manual (Page 150)

Paper and Other Media
48
3
DDDD
Push the bottom plate down until
it locks into place.
EEEE
Load envelopes into the Envelope
Feeder Unit, with the print side
down and the flap on the left as
shown in the illustration.
Important
❒ Confirm that the envelope flaps
are securely folded down, and
that there is no air inside the en-
velopes.
Note
❒ Confirm that the top of the stack
is not higher than the limit mark
on the side guides.
❒ Confirm that the envelopes fit
under the side guides.
❒ Do not push the stack of enve-
lopes with too much force.
FFFF
While pinching the side guides,
slide them along the edge of the
envelope stack.
GGGG
While pinching the rear guide,
slide it along the edge of the enve-
lope stack.
HHHH
While lifting the front of the tray,
place it into the printer. Then
slide it until it stops.
Important
❒ Do not slide the paper tray in
with force. If you do, the front
and side guides might move.
ZDDP360E
ZDDP380E
ZGDY370E
ZGDY390E