Ricoh AP2610N - Manual (Page 293)

Configuring Protocols
3
1
Configuring a Windows 95/98/Me computer
These steps are for configuring a Windows 95/98/Me computer to use the
TCP/IP protocol.
AAAA
Open [Control Panel] and then double-click the [Network] icon. Make sure that
“TCP/IP” is listed in the [The following network components are installed:] box on
the [Configuration] tab.
Note
❒ If the TCP/IP protocol is not installed, click [Add] on the [Configuration] tab
to install it. For more information about installing the TCP/IP protocol, see
Windows 95/98/Me Help.
BBBB
Configure the TCP/IP protocol with the appropriate IP address, subnet
mask and other settings.
Check with the network administrator that the settings are correct.
Configuring NetBEUI for Printing
These instructions are for configuring the Network Interface Board and Win-
dows 95/98/Me to use the NetBEUI protocol.
Preparation
To use NetBEUI, use the SmartNetMonitor for Client port.
Configuring the machine
Configure the machine to use the NetBEUI protocol.
• Make sure that the NetBEUI protocol is set to active. (The default is active.)
Reference
For more information about how to make the above settings, see the Setup
Guide.