Using in ad hoc mode – Ricoh AP2610N User Manual

Page 378

Advertising
background image

Appendix

88

7

Using in Ad hoc Mode

AAAA

Press

{{{{Menu}}}}.

"Menu" appears on the panel dis-
play.

BBBB

Press

{{{{U

U

U

U}}}} or {{{{T

T

T

T}}}} to display "Host

Interface", and then click

{{{{OK}}}}.

CCCC

Press

{{{{U

U

U

U}}}} or {{{{T

T

T

T}}}} to display "Net-

work Setup, and then click

{{{{OK}}}}.

The following is displayed when
installing the 802.11b Interface
Unit in the printer with Ethernet as
standard equipment.
If the 802.11b Interface Unit has
been installed in the printer with
Ethernet as standard equipment,
go to step

F

.

DDDD

Press

{{{{U

U

U

U}}}} or {{{{T

T

T

T}}}} to display "LAN

Type", and then click

{{{{OK}}}}.

EEEE

Press

{{{{U

U

U

U}}}} or {{{{T

T

T

T}}}} to display "IEEE

802.11b ", and then click

{{{{OK}}}}.

FFFF

Make the network settings. The
following items must be set:
• IP Address
• Subnet Mask
• Gateway Address
• Network Boot
• Frame Type (NW)
• Active Protocol
For more information about how
to make the settings, see the Setup
Guide.

GGGG

Make setting for the computer.
Set the transmission mode of the
IEEE 802.11b card installed in the
computer to ad hoc mode and the
channel to 11. Make the computer
network settings. The following
items must be set:
• IP Address
• Subnet Mask

Reference

For more information about
how to make setting for the
IEEE 802.11b card installed in
the computer and the computer
in use, see the appropriate oper-
ating instructions or consult
your network administrator.

Note

❒ Depending on the client soft-

ware of the IEEE 802.11b card
installed in the computer, the
channels might not be able to be
set. In this case, set the printer
channel to the channel specified
by the computer.

Menu:

Host Interface

Host Interface:

Network Setup

Network Setup:

LAN Type

LAN Type:

IEEE 802.11b

Advertising