Ricoh AP2610N - Manual (Page 371)

Monitoring and Configuring the Printer
81
7
Monitoring and Configuring the Printer
Changing Names and Comments
You can change printer names and make a comment on printers to easily iden-
tify the printers listed on SmartNetMonitor for Client.
The following utilities are used to change printer names and comments.
❖ ❖ ❖ ❖ SmartNetMonitor for Admin
Allows you to change names and comments when the TCP/IP protocol or
IPX/SPX protocol is available. You can install SmartNetMonitor for Admin
from the CD-ROM that comes with the printer. For more information about
installing SmartNetMonitor for Admin, see the Setup Guide.
❖ ❖ ❖ ❖ Web Browser
Allows you to change names and comments when the TCP/IP protocol is
available.
Note
❒ Each of the names, in a TCP/IP protocol form (printer name) and in a Net-
BEUI protocol form, is changed individually. Comments are, however,
common to both of them.
❒ The factory default name consists of "RNP" and the last 3 bytes of the MAC
address on the Network Interface Board. For example, when the MAC ad-
dress is 00:00:74:62:7D:D5, the factory default name is "RNP627DD5".
Comments are not configured.
SmartNetMonitor for Admin
AAAA
Run SmartNetMonitor for Admin.
BBBB
Click the [Group] menu, point to [Open LAN], and select [TCP/IP] or [IPX/SPX].
A list of printers appears.
Note
❒ Select the protocol of the printer you want to change its configuration.
CCCC
On the list, Select a printer whose Network Interface Board you want to
change its configuration.
DDDD
From the [Tools] menu, select [NIB Setup Tool].
The NIB Setup Tool starts up.