Cleaning the paper feed roller – Ricoh AP2610N User Manual

Page 196

Advertising
background image

Troubleshooting

94

5

Cleaning the Paper Feed
Roller

If the paper feed roller is dirty, a mis-
feed might occur. In this case, clean
the roller as follows:

R CAUTION:

Important

❒ The following are examples of

cleaning the paper feed roller on
the paper tray.

❒ You can clean the paper feed roller

on the optional Paper Feed Unit by
following the procedures below.
The paper feed roller on the op-
tional Paper Feed Unit differs from
the one on the paper tray. Confirm
the type of paper feed roller you
are installing.

AAAA

Turn off the power switch.

BBBB

Pull out the plug from the socket.
Remove all the cables from the
printer.

CCCC

Lift the paper tray slightly then
pull it out until it stops, and while
lifting the front side of the tray,
pull it out of the printer.

DDDD

Move the printer to the edge of a
stable table or desk.

Important

❒ Do not put the printer on an un-

stable or tilted surface.

❒ If the printer is equipped with

the optional Paper Feed Unit,
do not move the printer and
unit together as they are not se-
curely attached.

❒ When lifting the printer, con-

firm that the optional Paper
Feed Unit is not attached to the
printer.

When lifting the printer, use the

grips on both sides of the printer,
otherwise the printer might fall
and cause personal injury.

When you move the printer, un-

plug the power cord from the wall
outlet to avoid a fire or an electric
shock.

When you pull out the plug from

the socket, grip the plug to avoid
damaging the cord and causing
a fire or an electric shock.

ZCEM200E

For the paper tray

For the Paper Feed Unit

ZCEY140J

ZGDM110J

Advertising