Ricoh AP2610N - Manual (Page 309)

Using SmartNetMonitor for Client
19
2
Uninstalling SmartNetMonitor for Client
Preparation
Before uninstalling SmartNetMonitor for Client, make sure that:
• The port settings dialog box is closed.
• No printer is using the SmartNetMonitor for Client port as a printer port.
• You have performed login with the same user authority as that used to in-
stall SmartNetMonitor for Client.
AAAA
Open [Control Panel], and then double-click the [Add/Remove Programs] icon.
BBBB
Click the [Change or Remove Programs] tab, click [SmartNetMonitor for Client],
and then click [Change/Remove].
CCCC
After the confirmation message appears, click [Yes].
UninstallShield removes all of the components of SmartNetMonitor for Client.
DDDD
After the confirmation message appears, click [Yes].
EEEE
Acknowledge the [Remove Shared File?] dialog box.
FFFF
When the uninstallation is complete, click [OK].
Setting Up the Printer Driver
The following procedure allows you to configure the printer port to use Smart-
NetMonitor for Client.
Preparation
The target printer must be turned on before starting the installation process.
AAAA
Install the printer driver for the printer you want to use.
BBBB
From the [Printers] window, click the icon of the printer. On the [File] menu,
click [Properties].
CCCC
Click the [Ports] tab and click [Add Port].
DDDD
Click [SmartNetMonitor for Client] in the [Available port types:] box, and then
click [New Port].
The [Select Printer] dialog box appears and printers on the network are browsed.
The displayed items are as follows:
Model Name: The model name of the printer.
Name: The name of Network Interface Board.
Comment: Additional information about Network Interface Board.
Address: The IP address of the printer.