Ricoh AP2610N - Manual (Page 389)

Remote Maintenance by telnet
99
7
Note
❒ To specify the TCP/IP protocol, type ip followed by a space, and then the
IP address.
❒ To specify the IPX/SPX protocol, type ipx followed by a space, and then
the IPX address followed by a decimal, and then the MAC address of the
Network Interface Board.
The following is an example of how to configure registration number 3 with
the IP address 192.168.15.16.
msh> snmp 3 ip 192.168.15.16
The following is an example of how to configure registration number 3 with
the IPX address 7390A448, and the MAC address 00:00:74:62:5C:65.
msh> snmp 3 ipx 7390A448:000074625C65
IPP
Use the ipp command to configure the IPP settings.
❖ ❖ ❖ ❖ Viewing setting
The following command displays the current IPP settings.
msh> ipp
Example output:
timeout=900(sec)
auth basic
• The “timeout” setting specifies how many seconds the computer keeps try-
ing to access the network printer to send print jobs when no connection can
be made.
• The “auth” setting indicates the user authorization mode.
❖ ❖ ❖ ❖ IPP timeout configuration
Specify how many seconds to wait before canceling a print job if it has been
interrupted for some reason. The range of time can be changed between 30 to
65535 seconds.
msh> ipp timeout {30 - 65535}
❖ ❖ ❖ ❖ IPP user authorization configuration
Use the IPP user authorization to restrict users that can print with IPP. The de-
fault is “off” .
ipp auth {basic|digest|off}
• “basic” and “digest” are user authorization setting.
• “off” removes the user's authorization.
Note
❒ If you select “basic” or “digest”, see next section “Entry the IPP User Au-
thorization” for how to configure the user name. Up to ten user names are
available.