Configuring pp datasets, Subscribing pp datasets, Deleting pp datasets – AASTRA SIP-DECT (Release 2.1)- OM System Manual - Installation, Administration and Maintenance EN User Manual
Page 111: 6 configuring pp datasets, 7 subscribing pp datasets, 8 deleting pp datasets
SIP – DECT OM System Manual Release 2.1
6 OM Management Portal (OMP)
depl-1230/1.3
Page: 111 (196)
6.8.6
Configuring PP Datasets
Configuring PP datasets is only possible in configuration mode. To configure an existing
PP dataset proceed as follows:
1 In the task bar on the right of the
Portable parts
panel click on the
Configure
command.
– In the
Overview
submenu you can configure the whole PP dataset (user and device
data).
– In the
Users
submenu you can configure the PP user data.
– In the
Device
submenu you can configure the PP device data.
The PP detail panel opens.
2 Change the PP dataset as desired, see parameter description in chapter 6.8.4.
3 Press the
OK
button.
6.8.7
Subscribing PP Datasets
After adding a PP dataset to the OMM, the PP must be subscribed. The OMM must first be
enabled to allow subscriptions to be take place from PP handsets. Subscribing PP datasets
is possible in the
Overview
panel and in the
Device
panel. To start subscription, press one
of the following commands in the
Portable parts
menu:
•
Subscription
: start PP subscription with configured IPEI. For more information on this
see chapter 5.7.3.1.
•
Wildcard subscription
: start PP wildcard subscription (without configured IPEI). In the
Wildcard subscription
dialog, which is now opened, enter the
Timeout
for this
subscription method. Press the
Start
button. For more information on this see chapter
5.7.3.2.
6.8.8
Deleting PP Datasets
Deleting PP datasets is only possible in configuration mode. You can delete the fixed
PP dataset or only the PP user data resp. the PP device data.
To delete one or more existing PP datasets proceed as follows:
1 Select the appropriate PP dataset(s) in the PP table by activating the corresponding
checkbox(es).
2 In the task bar on the right of the
Portable parts
panel click on the
Delete
command.
– In the
Overview
submenu the whole PP dataset will be deleted.
– In the
Users
submenu only the PP user data will be deleted.
– In the
Devices
submenu only the PP device data will be deleted.
The
Delete [xxx]
dialog opens showing a confirmation prompt.
3 Confirm the displayed prompt with
OK
.