AASTRA SIP-DECT (Release 2.1)- OM System Manual - Installation, Administration and Maintenance EN - Manual (Page 61)

SIP – DECT OM System Manual Release 2.1 5 OMM Web Service
depl-1230/1.3 Page: 61 (196)
5.7.3 Subscribing PPs
Preparation by OMM Web service
After adding a PP configuration to the OMM, the PP must be subscribed. The OMM must first
be enabled to allow subscriptions to be take place from PP handsets. This is done by
pressing the following buttons on the Portable Parts OMM web page.
• Start button of the Subscription with configured IPEIs section (see chapter 5.7.3.1).
This button enables the subscription for the next 24 hours.
or
• Start button and time interval of the Wildcard Subscription section (see chapter 5.7.3.2).
This button enables the “wildcard subscription” for the selected time. After expiry the
“subscription with configured IPEIs” is still enabled for 24 hours.
Note: To ease the first installation of a DECT system, the subscription is enabled
permanently while at least one PP (with IPEI) is set up within the database and no
PP is subscribed. After successful subscription of the first PP the subscription will
still be enabled for 24 hours.
Note: To allow an unbound device subscription, the Auto-create on subscription flag
must be set with the help of the OM Management Portal (OMP). Please see chapter
6.5.1 for details.
Subscription steps, done by PP
After the PP configuration is complete on the OMM and the OMM is allowing new
subscriptions, each PP must subscribe to the system.
On each PP handset, the administrator or user must subscribe to the SIP – DECT system
through the System/Subscriptions menu. The specific PARK code for the SIP – DECT
system should be entered in order to subscribe to the system.
Please note: The PARK code in numeric format can be found at the top-right corner of the
Portable Parts OMM web page. Each SIP – DECT deployment will have a
unique PARK code that was provided with the OMM Activation kit.