AASTRA SIP-DECT (Release 2.1)- OM System Manual - Installation, Administration and Maintenance EN - Manual (Page 115)

SIP – DECT OM System Manual Release 2.1 6 OM Management Portal (OMP)
depl-1230/1.3 Page: 115 (196)
The following tasks can be performed:
• Create : create alarm trigger (see chapter 6.9.3.1).
• Configure : configure a selected alarm trigger (see chapter 6.9.3.2).
• Delete : delete selected alarm triggers (see chapter 6.9.3.3).
• Show details : shows parameters of a selected alarm trigger (see chapter 6.9.3.4).
6.9.3.1 Creating “Alarm triggers”
In configuration mode you can create new alarm triggers.
1 Click Create . In the General tab enter the alarm trigger parameters.
2 Trigger ID : Enter the Trigger ID. The Trigger ID identifies the alarm scenario and also
selects the source which triggers the alarm.
3 Feature access code : Enter the access code which should be assigned to the alarm
trigger.
4 Comment : Enter a comment for the new trigger.
5 Prefix : This field displays the FAC number which introduces the feature access code
(see also section 6.9.1).
6 Number : Enter the number to be called in case of this alarm trigger.
7 Press the OK button.
6.9.3.2 Configuring “Alarm triggers”
In configuration mode you can configure an existing alarm trigger.
1 In the alarm trigger table click on the appropriate trigger entry.
2 Click Configure .
The General tab is displayed showing the current trigger configuration.
3 Change the trigger parameters, see chapter 6.9.3.1.
4 Press the OK button.