AASTRA SIP-DECT (Release 2.1)- OM System Manual - Installation, Administration and Maintenance EN - Manual (Page 34)

SIP – DECT OM System Manual Release 2.1 5 OMM Web Service
depl-1230/1.3 Page: 34 (196)
• VLAN priority Call control : Determines the VLAN priority tag for VoIP-signaling packets.
• VLAN priority Audio : Determines the VLAN priority tag for RTP packets.
DECT settings
• PARK : This setting depends on the licensing mode:
Demo mode: shows the default PARK.
L-RFP systems: Enter the PARK key as labeled on the OpenMobility CD.
License file: shows the PARK included in the license file.
• Encryption : Encryption is only available on RFP 32/34/42 products. Therefore it can only
be enabled on the System Settings web page if there are no other Aastra RFP variants
connected to the OMM. If encryption is enabled and another RFP variant connects to the
OMM, its DECT air interface will not be activated.
Please note: Make sure that all deployed 3rd party handsets support DECT encryption. If
not, encryption can be disabled per device (see 6.8.4).
• DECT monitor : For monitoring the DECT system behavior of the OpenMobility Manager
the separate DECT monitor application exists. This tool needs an access to the
OpenMobility Manager which is disabled by default and can be enabled here. Because of
security, the DECT monitor flag is not stored permanently in the internal flash memory of
the OMM/RFP. After a reset the DECT monitor flag is ever disabled.
• Regulatory domain : To define where the IP DECT is used the parameter regulatory
domain has to be configured. Existing installations are updated to the default value
EMEA .
To setup a North American FCC compliant installation the value has to be set to
US (FCC/CI) . In a North American US (FCC/CI) deployment, ETSI compliant RFPs are
made inactive and can not be activated if the regulatory domain is set to US (FCC/CI) .
Vice-versa is also true. Only US (FCC/CI) DECT 142 handsets may be connected to
RFPs/OMM designed for the US market and configured to use the US (FCC/CI) regulatory
domain.
• DECT authentication code : The authentication code is used during initial PP
subscription as a security option (see chapter 5.7.1). A code entered here provides a
default DECT authentication code for each new created PP. It is optional.
Integrated message and alarm server
The OpenMobility Manager provides a integrated message and alarm server, which could be
activated/deactivated and configured here. For a detailed description see /24/.
Downloading new firmware to portable parts
If the
Active checkbox is enabled, the “Download over Air” feature is activated. The OMM is
acting as a download server which provides the firmware for downloads. For more
information on this feature please refer to section 7.15.
Syslog
The OMM and the RFPs are capable of propagating syslog messages. Enable the
Active
checkbox if you want to use this feature. Enter the IP address and the Port of the host which
should collect these messages.