AASTRA SIP-DECT (Release 2.1)- OM System Manual - Installation, Administration and Maintenance EN - Manual (Page 137)

SIP – DECT OM System Manual Release 2.1 7 Configuration und Administration Aspects
depl-1230/1.3 Page: 137 (196)
TFTP Server Address mandatory IP address of the TFTP server
TFTP File Name mandatory The boot file be read from the TFTP server at
startup.
TFTP server list optional List of additional TFTP servers to load the boot
file
Preferred TFTP server optional Try to load the boot file from ‘TFTP Server
Address’ as first.
OMM IP Address mandatory IP address of the OpenMobility Manager
Router addresses optional IP address of Default gateway
DNS Addresses optional IP address of DNS server
DNS Domain optional Domain name of the network
Broadcast Address optional The broadcast address for that network
2nd OMM IP Address optional IP address of the standby OMM
Country optional Defines the country in which the OMM resides to
handle country specific call progress tones.
NTP Server Address optional IP address of an NTP Server
NTP Server Name optional Name of an NTP Server
VLAN ID optional VLAN identifier
Use VLAN and DHCP optional The parameter defines whether only the local
VLAN configuration settings should be used
when booting or not.
Syslog IP Address optional Destination IP address for the syslog
Syslog Port optional Destination port for the syslog
Restore URL optional URL for an automatic OMM Database import
(see chapter 5.4.6.2 and chapter 6.5.4.1)
Configuration file server optional URL of a server with configuration files
(ipdect.cfg|<mac>.cfg) alternatively/in addition to
OM Configurator settings.
Syntax:
{ftp|ftps|http|https}://[user:password@]server/[dir
ectory/]
or
tftp://server/[directory/]
Core dump*
* can not be set via DHCP
optional In case of an system error the RFP creates core
dump files and transfers them using TFTP to the
folder configured in the TFTP file name.
The configuration can only be set after powering up or at the retry phase (LED flashing 0.25
Hz) or in kernel mode, please see chapter 7.5 for details. The OM Configurator tool waits
2 seconds and retries transmitting the data 3 times.
If you want to read the configuration parameters from an RFP, set the MAC address and the
IP address additionally and press the
List configuration button. All parameters will be listed
in the OM Configurator tool.