AASTRA SIP-DECT (Release 2.1)- OM System Manual - Installation, Administration and Maintenance EN - Manual (Page 96)

SIP – DECT OM System Manual Release 2.1 6 OM Management Portal (OMP)
depl-1230/1.3 Page: 96 (196)
6.7.1.6 Showing Synchronization Relations
You can view the synchronization relations of an RFP in monitor mode. Proceed as follows:
1 Select the appropriate RFP in the RFP table.
2 In the task bar on the right of the Radio fixed parts panel click on the Show sync
relations command.
The view switches to the Sync view menu . For further information see chapter 6.7.5.
Note: At least two RFPs must be selected for showing their synchronization relations.
6.7.1.7 Selecting Columns
You can adapt the parameters shown in the RFP table to your needs:
1 In the task bar on the right of the Radio fixed parts panel click on the Select columns
command.
The
Select columns dialog opens.
2 Select the columns that shall be shown by activating the appropriate checkboxes.
3 Click the OK button.
The RFP table will be adapted accordingly.
6.7.1.8 Filtering RFP Table
You can filter the list of RFP datasets shown in the RFP table by using a filter.
1 In the task bar on the right of the Radio fixed parts panel click on the Filter command.
The Filter RFPs dialog opens.