AASTRA SIP-DECT (Release 2.1)- OM System Manual - Installation, Administration and Maintenance EN - Manual (Page 90)

SIP – DECT OM System Manual Release 2.1 6 OM Management Portal (OMP)
depl-1230/1.3 Page: 90 (196)
6.7 “Radio fixed parts” Menu
RFPs can be configured and viewed in the Radio fixed parts menu. The Radio fixed parts
menu provides the following entries:
Configuration mode Monitor mode See chapter
Device list Device list 6.7.1
Paging areas 6.7.2
Enrolment 6.7.3
Export 6.7.4
Sync view 6.7.5
Statistics 6.7.6
6.7.1 “Device list” Menu
In the Device list panel, all configured RFPs are listed in a table. The device list is available
in configuration mode as well as in monitor mode.
Device list in configuration mode
The Active column shows the following states:
• – DECT is not enabled and/or RFP not connected.
• – DECT is enabled and RFP connected, but DECT has not been activated yet.
• – DECT is enabled and RFP is connected, but RFP is not synchronized and searches
for other synchronized RFPs.
• – DECT is enabled and RFP is connected and synchronized.
Note: If the Active column is not displayed, you can activate it in the Select columns
dialog, see chapter 6.7.1.7.