AASTRA SIP-DECT (Release 2.1)- OM System Manual - Installation, Administration and Maintenance EN - Manual (Page 165)

SIP – DECT OM System Manual Release 2.1 8 Maintenance
depl-1230/1.3 Page: 165 (196)
1 Press the Menu soft key.
2 Enter the following key sequence “R***76#”.
3 Select Auto Answer.
4 Press OK.
5 Enter a number of seconds the phone shall ring before it will answer the call.
6 Press OK.
7 Enter a number of seconds a call shall be active.
8 Press OK. The test will be started automatically.
9 To stop the test switch the phone off and on again.
8.3.4 Syslog
The OpenMobility Manager and the RFPs are capable of propagating Syslog messages
conforming to RFC 3164 (see /13/). This feature together with the IP address of a host
collecting these messages can be configured.
Syslog has to be enabled by:
• DHCP using the public options 227 and 228.
• Setting the syslog daemon server and port via the web interface.
To set up the syslog via DHCP or the OM Configurator has the advantage that syslogs are
available in earlier states of the RFP startup.
The level of syslog messages in the default state allows the user to have control over the
general system state and major failures.