AASTRA SIP-DECT (Release 2.1)- OM System Manual - Installation, Administration and Maintenance EN - Manual (Page 82)

SIP – DECT OM System Manual Release 2.1 6 OM Management Portal (OMP)
depl-1230/1.3 Page: 82 (196)
The following settings are only available in the OMP.
• Paging area size : Select the number of paging areas for the SIP – DECT system. A
paging area can consist of up to 16 RFPs. The configuration of the paging areas is done
in the
Paging areas menu of the OMP (see chapter 6.7.2).
• Auto-create on subscription : Activate this option if an unbound subscription of portable
parts should be allowed. Please see the SIP – DECT; OM Handset Sharing &
Provisioning; User Guide /26/ for details.
WLAN
For a description of the parameters which can be set in the
WLAN tab, please refer to the
description of the System settings page of the OMM Web service (see chapter 5.4.1). The
corresponding parameters can be found there in the WLAN settings page section.
6.5.2 “Statistics” Menu
The Statistics menu provides system statistics information. It contains a table with
numerous system statistics counters which can be used to check the system behavior. The
menu is only available in monitor mode.
Statistic counters beginning with “+” are counters which are taken over by standby OMM in
case of a failover. All other counters will be reset to the defaults in case of a failover. For
more details about the standby feature, see section 7.11.
The following tasks can be performed:
• Refresh all : request OMM update for all statistics counters create alarm trigger.
• Clear all : reset all statistics counters in OMM.