AASTRA SIP-DECT (Release 2.1)- OM System Manual - Installation, Administration and Maintenance EN - Manual (Page 71)

SIP – DECT OM System Manual Release 2.1 5 OMM Web Service
depl-1230/1.3 Page: 71 (196)
LDAP
A chosen number from a LDAP entry is checked against the external prefix pattern and if a
pattern matches it is replaced by the configured internal prefix pattern. Only the best
matching rule will be applied.
Before a rule is applied the following character are automatically removed from the LDAP
entry: ‘%’, space, ‘(’ and ‘)’. The result of the conversion is sent to the handset to be
displayed e.g. directory entry details and entered in the redial list.
Note: A conversion performed for a LDAP entry can be reversed if the rule is also
activated for an outgoing call.
Incoming Call
The calling party number of an incoming call is checked against the configured external
prefix pattern and if a pattern matches it will be replaced by the internal prefix pattern. Only
the best matching rule will be applied.
The result of the conversion is sent to the handset to be displayed and entered in the call
log
1 .
Outgoing Call
A dialled number of an outgoing call is checked against the configured internal prefix pattern
and if a pattern matches it will be replaced by the external prefix pattern. This applies to on-
bloc dialled numbers and to overlap sending as long as the SIP session has not been
initiated.
Note: To support digit treatment and overlap sending, it is necessary to have a dial
terminator configured.
The result of the conversion is not sent to the handset to be displayed or entered in the call
log
2 .
The following tasks can be performed on the Digit treatment page:
• creating and changing “Digit treatment” entries (see chapter 5.9.1.1),
• deleting “Digit treatment” entries(see chapter 5.9.1.2).
5.9.1.1 Creating and Changing “Digit treatment” Entries
1 To configure a new entry press the New button on the Digit treatment page.
To change the configuration of an existing entry click on the icon left behind the entry.
The
New digit treatment entry resp. the Configure digit treatment entry dialog opens.
1 For Incoming Call/Calling Party Number; Depending on the capabilities of the handset and
the level of integration.
2 For Outgoing Call/Called Number; If the user would dial the number from the redial list
again the same procedure will be applied as for the initial dialling.