AASTRA SIP-DECT (Release 2.1)- OM System Manual - Installation, Administration and Maintenance EN - Manual (Page 92)

SIP – DECT OM System Manual Release 2.1 6 OM Management Portal (OMP)
depl-1230/1.3 Page: 92 (196)
6.7.1.1 RFP Detail Panel
The RFP detail panel is used for configuration/showing of RFP settings and creation of new
RFP datasets.
To call up the RFP detail panel
• choose one of the commands in the task bar on the right of the Radio fixed parts panel
( Create , Configure , or Show details )
or
• select the appropriate RFP in the RFP table and double-click the entry.
The RFP detail panel contains the following parameter groups sorted in different tabs.
“Status” tab
This tab is only available in monitor mode. It shows system status information relating to the
selected RFP.
“General” tab
This tab contains the general RFP parameters.