AASTRA SIP-DECT (Release 2.1)- OM System Manual - Installation, Administration and Maintenance EN - Manual (Page 95)

SIP – DECT OM System Manual Release 2.1 6 OM Management Portal (OMP)
depl-1230/1.3 Page: 95 (196)
“WLAN” tab
Settings in the
WLAN tab apply to RFPs of the type “RFP 42 WLAN” and “RFP L42 WLAN”
only. For details about WLAN configurations please see chapter 7.13.
For a description of the parameters which can be set in the WLAN tab, please refer to the
description of the Radio fixed parts page of the OMM Web service (see chapter 5.6.3). The
corresponding parameters can be found there in the WLAN settings section.
Note: Configuration of WLAN profiles is only possible with the OM Web service, see
chapter 5.8.1.
6.7.1.3 Changing RFPs
Changing RFPs is only possible in configuration mode. To change the configuration of an
existing RFP proceed as follows:
1 Select the appropriate RFP in the RFP table.
2 In the task bar on the right of the Radio fixed parts panel click on the Configure
command.
The RFP detail panel opens, see chapter 6.7.1.1.
3 Change RFP parameters, see parameter description in chapter 6.7.1.3.
4 Press the OK button.
6.7.1.4 Viewing RFP Details
You can view the configuration of an RFP in monitor mode. Proceed as follows:
1 Select the appropriate RFP in the RFP table.
2 In the task bar on the right of the Radio fixed parts panel click on the Show details
command.
The RFP detail panel opens, see chapter 6.7.1.1.
3 To close the RFP detail panel press the Cancel button.
6.7.1.5 Deleting RFPs
Deleting RFPs is only possible in configuration mode. To delete one or more existing RFPs
proceed as follows:
1 Select the appropriate RFP(s) in the RFP table by activating the corresponding
checkbox(es).
2 In the task bar on the right of the Radio fixed parts panel click on the Delete command.
The Delete RFP dialog opens showing a confirmation prompt.
3 Confirm the displayed prompt with OK .
Please note: <Ergänzung>If a Licence RFP was deleted, a new license file will be required!
For further information on licenses see chapter 4). </Ergänzung>