Franklin Fueling Systems Tank Sentinel (TS-1001, 2001, 504, & 508) Setup Programming Guide - Manual (Page 100)

Leak Detection Sensors Page 17 - 5 17
Worksheet # 17-2 – Output Groups – Sensor Channels 9 to 16
Fill-in the work sheet below and compare assignments with other work-sheets to
uncover conflicts before programming output devices.
A maximum of
3 alarm Output
Groups ( OG )
can appear per
channel # N...
TSP-DDS &
TSP-DTS
sensors have
3 alarms:
water,
product &
sump full.
Alarm OGs are:
STD (standard)
PROD
(product)
WATER OG
SMP FL
(sump full)
DRY WL
(dry well)
HGH BR (high
brine level)
LOW BR (low
brine level)
VAPOR OG
Write-in all
alarm OGs
for each
sensor
channel #.
OG = Output Group - Output Group Assignment WORKSHEET Output Group choices -
Sensor Chnl #9: NONE
A
B
C
Sensor Chnl #10: D
E
F
G
Sensor Chnl #11: H
I
J
K
Sensor Chnl #12:
L
M
N
O
Sensor Chnl #13: P
Q
R
S
Sensor Chnl #14: T
U
V
W
Sensor Chnl #15: X
Y
Z
AA
Sensor Chnl #16: BB
CC
DD
EE
example: WATER OG 10 1 W Could activate the annunciator when water is detected (TSP-DTS) FF
PROD OG 10 1 P
Could activate the annunciator and a ROM relay (output)
to disable dispensing if product is detected (TSP-DIS shown)
ALL
SMP FL OG 10 2 R
Could activate the annunciator and a ROM relay (output) to warn
that the sump is full and to be pumped out (into a containment tank)
Output Devices: Modulated Annunciator, Solid Annunciator, Relay 1, Relay 2, I/O Output Module
Channel # 1 to # __ (record all OG Assignments in the vertical column)