Franklin Fueling Systems Tank Sentinel (TS-1001, 2001, 504, & 508) Setup Programming Guide - Manual (Page 39)

4 Page 4 - 4 Tank Sentinel Setup Programming Guide
Probes – SPECIAL Menu
The SPECIAL menu appears when at least one
SPEC PROBE N was selected from the
PROBES – DATA – TYPE menu (above).
This menu shows all possible choices BUT
only the selected SPECIAL PROBES N are
displayed.
SPECIAL
SPECIAL PROBES
SPECIAL 1 Press ( M ) key to select a SPECIAL # probe.
SPECIAL 2
: N = Special Probe # 1 thru # 8 and may or may not
SPECIAL 8 agree with the actual Tank number or Probe input
SPECIAL PROBE N channel number.
COPY (Optional - used to copy probe data)
COPY FROM SPECIAL PROBE X TO N Select a probe to copy data from (use M key).
PROBE 1
PROBE 2
Press UP/DOWN ▲ ▼ keys to choose a probe #.
: Press ENTER to accept this data.
PROBE 8
COPY FROM SPECIAL PROBE X TO N
PRESS ENTER IF YOU ARE SURE?
Press ENTER to accept this data.
(press CANCEL to prevent copying the POS#)
LENGTH
SENSOR LENGTH N
53 0 to 999 (Use keypad to enter probe length.)
Press ENTER to accept this data.
RTD POS (RTD Temperature sensor positions are printed on
RTD POSITION TABLE N the probe label on the probe head)
ADD Press M1 key.
RTD POSITION TABLE N
+0 Use the keypad to enter each RTD number.
Press ENTER to accept this data.
(input all 6 RTD positions as printed on the label.)
DELETE Press M2 key.
SELECT POSITION WITH UP/DN POS X Press UP/DOWN ▲ ▼ keys to choose a POS #.
+NN.NNNN or TABLE IS EMPTY Press ENTER to Delete an RTD POS #.
ARE YOU SURE? Press ENTER to accept this data.
(press CANCEL to prevent deleting the POS#)
EDIT Press M3 key.
SELECT POSITION WITH UP/DN POS X Press UP/DOWN ▲ ▼ keys to choose a POS #.
+NN.NNNN or TABLE IS EMPTY Press ENTER to reset the POS # to (+0).
Use keypad to EDIT RTD POS#.
Press
ENTER to accept this data.
DISPLAY Press M4 key.
RTD POSITION TABLE N POS X Press UP/DOWN ▲ ▼ keys to scroll POS #.
+NN.NNNN or TABLE IS EMPTY Press CANCEL to return to the menu.
PROBES
D ATA SPECIAL
M1 M2 M3 M4