Franklin Fueling Systems Tank Sentinel (TS-1001, 2001, 504, & 508) Setup Programming Guide - Manual (Page 160)

Diagnostic Menu Page 28 - 1 28
28 Di agnostic Menu
DIAG Menu
H U
MENU
×
Press this key and follow the
7
highlighted sequence below
Contents:
Diag Menu
Diag Navigation &
Descriptions
TPI Diagnostic Function Notes
RESET Menu
DIPSW Menu
CALIBRT Menu
Calibration Procedure
❋ The DIAG menu appears only when the optional
feature TPI is enabled and AUTO CFG has been
performed.
DIAG Navigation & Descriptions
Follow these navigation steps to display the
DIAG menu:
Press the M2 key below DIAG to show the
PUMPS menu.
Press the M1 key under PUMPS to display the
SELECT PUMP menu.
The SELECT PUMP menu displays all of the pump
numbers that are communicating with the Tank
Sentinel.
Press the ( M ) key under each pump number to
display the SELECT DIAGNOSTIC OPTION menu.
In this example, press the
M1 key for the PUMP 1
options.
Here is the DIAGNOSTIC OPTION menu showing
menu names for the three available functions.
— proceed to the next section - TPI
Diagnostic Function Notes —
SELECT MENU OPTION (MORE)
SETUP UPGRADE LANGUAGE DATALOG
Press the DOWN ▼ key once ....
NOTE
☞
SETUP MENU OPTION
P U M P S
M1 M2 M3 M4
M1 M2 M3 M4
SELECT PUMP (MORE)
P U M P 1 PUMP 2 PUMP 3 PUMP 4
S E L E C T M E N U O P T I O N
D IS P L AY
DIAG
M1 M2 M3 M4
SELECT DIAGNOSTIC OPTION
RESET DIPSW CALIBRT
M1 M2 M3 M4