Franklin Fueling Systems Tank Sentinel (TS-1001, 2001, 504, & 508) Setup Programming Guide - Manual (Page 55)

DIM Setup Page 8 - 3 8
DIM menu (Continued... FROM PREVIOUS PAGE)
(In most applications using one TS-DIM unit, keep these default settings)
FUEL PTS
Press M2 key.
FUELING POINTS
FUEL P N Press M1 key.
FUELING PT N
DIM UNIT Press M1 key.
DIM UNIT NUMBER - FUEL PT N
1 Enter the TS-DIM unit number connected to this
fueling point.
Use keypad to input a number.
Press ENTER to accept this data.
DIM FL PT Press M2 key.
DIM FUELING POINT - FUEL PT N
1 1 - 16
Use keypad to input a number.
Press ENTER to accept this data.
— Press the CANCEL key to display the FUELING POINTS Menu —
— Repeat the above setup steps for each FUELING POINT —
— Press the CANCEL key to display the DISPENSER INTERFACE Menu —
DIMS Press M3 key.
DIMS
DIM N Press M1 key.
DIM N
ADDRESS
Press M1 key.
DIM ADDRESS - DIM N
1 1 - 8 Enter the same number as the jumper
location found inside the TS-DIM unit.
Use keypad to input a number.
Press
ENTER to accept this data.
— Press the CANCEL key to display the DIMS Menu —
— Repeat the above setup steps for each DIM number —
— Press the CANCEL key 2 times to display the main SETUP Menu —