26 data log menu 26, Data log menu 26, Data logging notes 26 – Franklin Fueling Systems Tank Sentinel (TS-1001, 2001, 504, & 508) Setup Programming Guide User Manual
Page 153: 26 data log menu, Data log menu
Data Log Menu
Page
26 - 1
26
26
Data Log Menu
Data Log Menu
H
U
MENU
×
Press this key and follow the
7
highlighted sequence below
Contents:
Data Log Menu
Data Logging Notes
See the Table of Contents to find topics in
this manual. See the Preface for general
information about this manual. See the
Installation, Operator’s, TroubleShooting
Guides and Application Notes for other
reference sources.
Data Logging Notes
This menu can be ignored
unless
diagnostic
tank data is required.
•
In order to access this menu:
a 9 pin
communications cable must be plugged
into Comm Port 1 or Comm Port 2 at the
Tank Sentinel console (the other end plugs
into a serial communications port of a IBM
compatible computer).
This must be done with power off at the
computer and Tank Sentinel console.
•
Instructions and requirements about this
feature will be supplied by INCON Technical
Service.
Press a menu select key (
M1
thru
M4
) to
choose a tank. Use
UP
/
DOWN
for more
tanks (TS-2001/508 consoles can monitor
up to 8 tanks).
SELECT DATALOG
START
STOP ...(Ends Data Logging)
M1
M2
M3
M4
START DATALOG
(MORE)
TANK 1
TANK 2
TANK 3
...TANK 8
M1
M2
M3
M4
SELECT DATALOG
START
STOP
M1
M2
M3
M4
DATALOG
COMM 1
COMM 2
M1
M2
M3
M4
SELECT MENU OPTION
SETUP
UPGRADE LANGUAGE
DATALOG
M1
M2
M3
M4