Yokogawa DAQWORX - Manual (Page 105)

2-75 IM WX103-01E
1
2
3
4
5
Index
Logger
Click the Stop Rec button or the Stop button on the tool bar, or select Stop Recordng
from the Acquston menu. Click OK in the dialog box that is displayed (like the one
below).
Click OK. When you click OK, the word “Stop Rec.” on the button changes to “Saving”
until the recording actually stops.
Explanaton
Startng/Stoppng the Recordng
Data is recorded according to the Start condition and Stop condition specified on the
Acquisition setup screen. Recording starts immediately when you click the Start Rec
button only when Start Condition is set to On Record. For all other settings, the detection
of whether the start condition is met is started when you click the Start Rec button.
Note
• The creation of the data file starts after the recording is stopped. Therefore, it may take time
for the data save operation to complete.
• You cannot exit the software if the saving of the data is not complete. If you attempt to do
so, a dialog box with the message “Writing data files Currently” opens. In this case, the
remaining number of data files to be finalized is displayed to the left of the icon indicating
that the writing is in progress on the status display bar (see page 2-43) at the bottom section
of the Main window. You can close the software when this number indication clears.
• If the specified directory for saving files does not exist when recording is started, the
directory is created. If the directory cannot be created, the files are saved to the Data
directory in the MXLOGGER installation directory.
• Do not specify the file save destination to a non-writable drive.
Run Dsplay
The Run screen displays the run information. For a description of the displayed contents
on the Run screen other than those described below, see the explanation in section 2.10,
“Starting/Stopping Data Monitoring and Displaying the Monitor.”
• Record Informaton
Record time
File creation progress indication bar
Move the mouse pointer here to display the remaining time value
Estimated completion time of the file currently being created
Estimated size of the file currently being created
Number of data files created
• Fles created n the past
Record files created in the past
Select a file and click the Open
button to start the Viewer.
(You can also double-click to
start the program.)
2.12 Startng and Stoppng Data Recordng