Yokogawa DAQWORX - Manual (Page 75)

2-45 IM WX103-01E
1
2
3
4
5
Index
Logger
7. Click the Power ON box under
Specified Output and select Hold or Preset Value.
8. Click the Error box under
Specified Output and select Hold or Preset Value.
9. If you select Preset Value under
Specified Output, click Preset Value and enter
the duty.
10. Select 1 msec or 10 msec in the Resoluton box under Pulse.
Click the Interval (msec) box under Pulse, and enter the pulse interval.
11. Click the Default box under Pattern Output and select ON or OFF for the initial
operation in the loop settings.
12. Click the Type box under Pattern Output and select Contnuous or Tmes.
13. If you select Tmes for Type under Pattern Output, click the Count box under
Pattern Output, and enter the number of loops.
14. Click Edt under Pattern Output to open the Edt Pattern window.
Scroll to select an action or set the reference channel, or span
Set the output value upon startup or error occurrence
Set the default pattern
output and set the type
and times.
Edit pattern button for pattern output
Select the resolution of the pulse output
Enter the
pulse interval
Select the output action upon startup
Select the output action upon errors
15. Edit the output pattern in the Pattern Edt window. For instructions, see “Editing
Pattern Output” in this section.
Edtng Pattern Output
Addng Ponts
1. Click Edt under Pattern Output to open the Edt Pattern window.
2. Click the Add button under Edt Pattern to open the New Pont window. (To edit at
a particular time after the previous point, click the Insert button instead. )
3. Enter an elapsed time from the start time (or from the previous point) in the Tme box
in the New Pont window.
4. Enter an output value in the setting box in the New Pont window.
5. Click OK in the New Pont window to create the new point.
Edtng Ponts
1. Click the point you wish to edit in the Edt Pattern window. The point changes from
gray (or orange) to red.
2.8 Analog/PWM Output Settngs