Yokogawa DAQWORX - Manual (Page 73)

2-43 IM WX103-01E
1
2
3
4
5
Index
Logger
2.8 Analog/PWM Output Settngs
Procedure
Settng Analog Output
1. Click Channel to show the Channel setup screen.
2. Click the AO Channel tab.
3. Select the Use check boxes for the AO channels you wish to output.
4. Specify a channel operation of Transmsson Output or User Output 1 through
User Output 4
. If user output is specified, you can enter settings in the monitor
screen.
Of all the AO and PWM channels selected for user output, only one can be specified
for each channel, for a total of four.
5. When Transmsson Output
is specified, enter the reference channel. The
Reference Channel cannot be entered if the channel operation is user output.
6. Select a range from the Range list box.
7. Click the Mn box or Max box under Span and enter the minimum or the maximum
value of the span.
Select the source action Select the
output range
Transmission output reference channel
Select output or no output
Scroll to set the output action and pattern output
Minimum/Maximum value
setting for the output span
Click here Click the AO Channel tab.
8. Click the Power ON box under
Specified Output and select Hold or Preset Value.
9. Click the Error box under
Specified Output and select Hold or Preset Value.
10. If you select Preset Value under
Specified Output, click Preset Value under
operation, and enter the voltage or current.
11. Click the Default box under Pattern Output and select ON or OFF for the initial
operation in the loop settings.
12. Click the Type box under Pattern Output and select Contnuous or Tmes.
13. If you select Tmes for Type under Pattern Output, click the Count box under
Pattern Output, and enter the number of loops.