Yokogawa DAQWORX - Manual (Page 9)

1-2 IM WX103-01E
• Vewer
You can use the Viewer to (1) display measured and computed data that has been
recorded (saved), (2) read values and perform statistical computation over an area
using cursors, and (3) convert the measured and computed data into various file
formats such as Excel.
• Calbrator
You can use the Calibrator to calibrate the MX100 universal input modules.
Logger
On the Logger, the following screens (windows) are used to enter settings.
• System Screen
On this screen, you can search for MX100s in the same network segment, set
communication parameters of the detected MX100s such as the IP address, select
the MX100s to be connected, select measurement groups (groups that have the same
monitor interval/record interval), and perform other functions.
• Acquston Screen
You can set the monitor interval of the measured data, the record step of the data,
and the record start/stop conditions. You can also set the save destination and the file
name of the record data, set up the file division function, and perform other functions.
• Channel Setup Screen
For each measurement channel, you can set (1) the measurement conditions such
as the input mode, measurement range, and measurement span, (2) whether to
carry out measurement/recording, and (3) the alarm conditions. You can also set
up computations such as the four arithmetical operations using the measured data
(computation channel setting), set the signal to be output from the digital output
module (DO channel setting), and set up modules such as the analog output and
PWM output modules.
• General Dsplay Settngs Wndow
For each display group, you can set the channels to be displayed, display scale,
display zone, trip point (the value of interest in the waveform display), display color,
and other parameters.
1.1 Functonal Overvew of MXLOGGER