14 setting up the monitor server, Starting and exiting the monitor server, Changing the port number – Yokogawa DAQWORX User Manual
Page 109: 14 setting up the monitor server -79, Starting and exiting the monitor server -79, Changing the port number -79, 14 settng up the montor server, Index, Startng and extng the montor server, Changng the port number
2-79
IM WX103-01E
1
2
3
4
5
Index
Logger
2.14 Settng Up the Montor Server
Procedure
Startng and Extng the Montor Server
Startng
Click the Monitor Server button on the toolbar or choose Run Server from the Fle menu.
Click here
or
The Monitor Server window opens as shown below.
Status display bar at the bottom section of the Main window
Click here to display the Monitor Server window
Displayed only when the Monitor Server is running
Extng
On the Monitor Server window, choose Ext from the Montor Server menu.
Choose this.
Changng the Port Number
1. From the Fle menu, choose Port No..
The Port No. dialog box opens.
2. Enter the desired port number in the Port No. box and click OK.
Port number (50284 by default)
Use this port number unless this number is
being used by another software program
3. In the dialog box with the message “Port No. is available for next time.” click OK.
Then, restart the server to activate the new port number.