Yokogawa DAQWORX - Manual (Page 35)

2-5 IM WX103-01E
1
2
3
4
5
Index
Logger
2.2 Confgurng the System
Procedure
To perform the procedure below, you usually have the icons of the MX100s you wish to
connect shown in the MXs nearby area of the System screen according the instructions
given in section 2.1, “Searching MX100 Data Acquisition Units and Configuring the Network.”
Selectng the MX100s That Are to Montor the Data
Drag the MX100 icon displayed in the MXs nearby area onto the Configuration area. A dialog
box with the message “Invalid modules exist. Do you get configuration after reconstructing?”
appears. Click Yes. To monitor the data from multiple MX100s, repeat this procedure.
Drag and drop the icon of the MX100 you wish to connect to the Configuration area
The order in which the MX100 icon is dragged and dropped determines the unit number,
which is the highest two digits of the channel number. The unit number of the first MX100
that is dragged and dropped is assigned the number 0. The following MX100s are assigned
numbers 1 to 19 in order. If you wish to change the unit number, click the MX100 you wish
to change and click the Up or Down button to move the display position up or down.
Unit number
To remove the MX100 that was placed in the Configuration area from the system,
click the relevant MX100 and then click here.
To change the unit number of the MX100, click the MX100 you wish to change and then click here.
Note
Instead of dragging and dropping the icons onto the Configuration area, you can also drag and
drop the icons to the respective measurement groups under Meas Groups. If you do so, all input
modules of the MX100 are assigned to the measurement group where the icon was dropped.