Yokogawa DAQWORX - Manual (Page 76)

2-46 IM WX103-01E
2. Click the Edt button under Edt Pattern to open the Edt Pont window (you can
double-click a point to open the Edt Pont window even if it is red.)
3. Perform the same procedure as when editing new points.
Deletng Ponts
1. Click the point you wish to edit in the Edt Pattern window. The point changes from
gray (or orange) to red.
2. Click the Delete button under Edt Pattern to delete a point .
Select to enable. The Add button in the
bottom right of the window changes to
the Insert button.
Select the “Elapsed time from point before” check box under
Edit Pattern to change the display to that of the elapsed time
from point before.
The point that can be edited appears in red
For voltage output on the analog
output module, the Y-axis units are V
For current output on the analog
output module, the Y-axis units are I
For PWM output on the
analog output module,
the Y-axis units are %
Click to add a new point
Enter the elapsed time
Edit the point displayed in red
Deletes the point displayed in red
Enter the setting value
The units change to match the module setting
2.8 Analog/PWM Output Settngs