Setting the a/d integration time, Setting the temperature unit for tc and rtd, Mx100 response check – Yokogawa DAQWORX User Manual
Page 38: Setting the a/d integration time -8, Setting the temperature unit for tc and rtd -8, Mx100 response check -8, Settng the a/d integraton tme, Settng the temperature unt for tc and rtd
2-8
IM WX103-01E
Note
You can select multiple module icons simultaneously to be dragged and dropped by selecting
the module icons in the Meas Groups area while holding down the Shift or Ctrl key.The Shift
key is used to select a range of icons. The Ctrl key is used to select icons individually.
Confgurng a System Usng MX100s That Are Not Connected
Click the Add button in the Configuration area to display a virtual MX100. In this area,
you can configure the module and select the measurement group using the procedure
described earlier. This function is useful when configuring MX100s that are not connected
in advance.
Click here.
Virtual MX100
Enter the IP address or
host name of the MX100 to connect
Settng the A/D Integraton Tme
From the A/D Integraton Tme list box in the Configuration area, select AUTO, 50 Hz,
or 60 Hz.
Select the A/D integration time.
Settng the Temperature Unt for TC and RTD
From the Temp. Unt list box, select C or F.
Select the temperature unit.
MX100 Response Check
Click the Response button in each MX100 in the Configuration area. If the MX100
is connected, the 7-segment LED on the main module of the corresponding MX100
displays —CALL—.
Click here.
2.2 Confgurng the System