Yokogawa DAQWORX - Manual (Page 138)

3-25 IM WX103-01E
1
2
3
4
5
Index
V
ewer
Converson Range and Step
You can specify the range using data numbers or by using cursors. For the method
of specifying the range using cursors, see the procedure in section 3.4, “Statistical
Computation over an Area of Measured/Computed Data.”
By specifying the step, you can save data sampled at certain intervals rather than
converting all the data in the range (when step is set to 1).
Specfyng Formats
Select the format for the converted data. When outputting channel data in columns select
Normal, and for rows, select Trans position.
Display Example of the Converted Data (normal) Display Example of the Converted Data (trans position)
Version
Version Version
Version
Notes When Convertng Data
• There is a limit in the number of data points that Excel and Lotus1-2-3 can handle.
Before executing the conversion, set the channels/groups to be converted, the
conversion range, and the step so that the number of data points is appropriate. If the
limit is exceeded, perform automatic division prior to conversion. Serial numbers are
attached to divided-converted files. In addition, if the free memory space on the PC is
low, you may not be able to load the data using Excel or Lotus 1-2-3.
• If you set the save destination to a storage medium that has slow access such as a
floppy disk, the saving of the data may take an extended time. It is recommended that
such storage medium not be selected for the save destination.
• Select a save destination with adequate free space.
• The measured data during a burnout or measured data that exceeds the upper/lower
limit of the measurement range are indicated as “+OVER” or “-OVER”
• If invalid data exists in the converted data (measured value of a channel without input
or computed value when the data used in the equation does not exist), the data is
indicated as “INVALID”
3.7 Convertng Data Formats