Yokogawa DR240 - Manual (Page 158)

9-16 IM DR232-01E
9.4 Clearing Alarm/Message Buffers, Displaying Module/
Communications Information, Structuring System
Modules, and Initializing Information
D I S P M O D E
P R I N T F U N C
I N S D E L
R A N G E A L A R M
S E T C H A R T E N T E R
F E E D
M. F U N C 1
M. F U N C 2
RECORD
ALARM
CHART
KEYLOCK
R E C O R D
ALM_BUF_CLEAR
>Select Function item
E S C
↓ ALM_BUF_CLEAR MSG_BUF_CLEAR MODULE_INF ↑
• Press and hold the FUNC key for about three seconds to enter the FUNC3 menu.
• To enter the FUNC menu from the [RANGE], [ALARM], [CHART], or [SET] (SET3) menu,
press the DISP key.
• Select/set using the keys.
• To escape from a lower menu, press the MODE (ESC) key. Its main menu will appear,
although new settings/selections will not be kept.
• There may be some menus that are not displayed by basic settings in Chapter 10.
ALM BUF CLEAR
MSG BUF CLEAR
MODULE INF
COMM INF
RE SYSTEM
RAM INIT
S UNIT0:INF=SYSTEM
0 1 2 3 4 5
S UNIT0:INF=SYSTEM
SYSTEM REAL
MODULE=GP-IB
>ADDR=01
MODULE=RS-232C
>BIT RATE=19200 LENGTH=8BIT PARITY=NONE
>STOP=1BIT HANDSHAKE=OFF:OFF
RE SYSTEM=NO
RE SYSTEM=YES
SYSTEM RESTRUCTING
RAM INIT=NO
RAM INIT=YES
RAM INITIALIZING
ENTER Operating status
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER
(After about
15 seconds)
ENTER
ENTER
ENTER
(After about 10 seconds)
ENTER
ENTER
(For GP-IB interface)
(For RS-232-C interface)
ENTER
(Lower menu)
(Main menu)