Yokogawa DR240 - Manual (Page 213)

11-18 IM DR232-01E
Measured/computed data in the internal RAM disk is converted to ASCII data, then copied to a
floppy disk. The identifier is .CSV.
Conversion channel (COPY CH)
Used to select a channel whose data is to be converted to ASCII data. Measurement channels and
computation channels are arranged in the order of 001, 002, ... 560, A01, A02, ... A60. For
instance, if “559-A02” is specified, data for channels 559, 560, A01 and A02 will be converted.
Conversion data (COPY DATA)
Used to specify the conversion range for the channels specified by COPY CH. Enter the
conversion start data No. and end data No.
Data size
When measured/computed data is converted to ASCII data, 12 bytes will be used for each data
set. Thus, data size can be calculated as follows.
Data size = 178 + 20 x number of conversion channels - 2 + (24 + 12 x number of conversion
channels -1) x number of data sets to be converted
Copying is not possible if destination’s memory size is insufficient.
Note
When a file is copied to a floppy disk, the file creation date will be replaced by the date on which the file is
copied.
11.6 Copying in ASCII Format