Yokogawa DR240 - Manual (Page 165)

10-4 IM DR232-01E
10.2 Setting Recording Format
Selection of Channel Number or Tag (CH OR TAG)
Select the call name for printing or displaying the measured values of either CHANNEL or TAG.
• Select either CHANNEL or TAG. However, if the TAG setting includes all spaces (vacant),
the channel is printed or displayed regardless of selection.
• The default setting is CHANNEL.
• For the TAG setting, see Section 6.4, “Setting Tag, Digital Printout and Manual Printout” (page
6-8).
Selection of Number of TAG Printing Characters
• Select 7, 8, 9, 10, 11, 12, 13, 14, 15 or 16.
• The default setting is 7.
• If the number of printing characters is less than the set TAG set in Sect. 6. 4. Only the
number selected here will be printed.
• For the number of characters when displaying, see chapter 4.
Selection of Dot-printing Recording System
Select it from the following systems. The default setting is NORMAL. To practically record it,
the RECORD must be turned on. Channels to be recorded are those selected to be ON in “Setting
the Channels to be Recorded, Dot Recording” on page 6-2.
• NORMAL:
• Records all channels to be recorded.
• ALARM1:
• Records only those channels in which alarms are generated.
• Continues recording even if the alarm is reset.
• ALARM2:
• Records only the channels in which alarms are generated.
• Stops recording when the alarm is reset.
• GROUP:
• Records the channels which are set into a group (see page 6-16).
• Recording can be done only if “GR TREND” is set in the event/action function.