Yokogawa DR240 - Manual (Page 206)

11-11 IM DR232-01E
Saving/Reading Measured, Computed and Set-up Data
11
Saving set-up data for the SETUP mode
D I S P M O D E
P R I N T F U N C
I N S D E L
R A N G E A L A R M
S E T C H A R T E N T E R
F E E D
M. F U N C 1
M. F U N C 2
RECORD
ALARM
CHART
KEYLOCK
R E C O R D
SETUP=FLOPY
↓ PRN_ADJ SCAN_INTV RECORD MATH FLOPPY ↑
>Select Setting Parameter
E S C
• Carry out the following steps to enter the SET UP menu.
1. If the SET UP menu is not currently displayed, turn the power OFF
2. While holding the DISP key, turn the power ON. Make sure depression of the DISP key is
maintained for approximately another five seconds..
• Select/set using the keys.
• To escape from a lower menu, press the MODE (ESC) key. Its main menu will appear,
although new settings/selections will not be kept.
SET UP=
(Main menu)
FLOPPY FLOPPY=SAVE
SAVE LOAD DELETE INFO FORMAT
SAVE file=
_____ AAA BBB CCC
SAVE FILE=AAA
Saving... *
***SAVE OK***
(End of saving) ESC
ENTER
ENTER
ENTER ENTER
Set-up data except for date/time is saved to the internal RAM disk or a floppy disk. Set-up data
for the SETUP mode can be saved to a floppy disk only. Data is always saved in ASCII format.
The file name must consist of up to 8 characters. The following identifier is used.
Set-up data file for SET mode : .PNL
Set-up data file for SETUP mode : .SET
Data size
Set-up data for the SET mode: Up to approximately 250 KB (300 measurement channels
and 60 computation channels) are available for set-up data for the
SET mode.
Set-up data for SET OR mode: Approx. 50 KB (max) (for 300 measurement channels and
60 computation channels)
Note
• “Saving ...*” will be displayed during saving. During this period, key board operations are not possible.
• No saving is allowed during computing.
• The communication function remains disabled during saving.
11.3 Saving Set-up Data