Yokogawa DR240 - Manual (Page 184)

10-23 IM DR232-01E
10
Basic Settings (SET UP)
Setting SET/SET3 (SET PARM)
Select the menu to be displayed by pressing the SET key whether in the SET menu or the SET3
menu. The SET menu is displayed by pressing the SET key at a touch and the SET3 menu is
displayed by pressing the SET key for about 3 seconds continuously.
• Select any of the following:
• SET: displayed in the SET menu.
• SET3: displayed in the SET3 menu.
• OFF: not displayed in either menu.
• The default setting is as shown in the operating procedure diagram on pages 10-20 and 10-21.
• The last operation menu, “PANEL:ALL ITEM,” is the menu that globally set all menus.
However, the selection of “INIT” selects the default setting.
Note
• In order to make the set or selected contents effective, the contents must be registered. For details, see
page 10-23.
• To return from the SET UP menu to the operation display mode, select END in the main menu. For
details, see page 10-23.
10.9 Setting SET/SET3 Menu