Avaya C460 - Manual (Page 119)

Chapter 2 Avaya C460 CLI Commands
Avaya C460 Reference Guide 107
The syntax for this command is:
set port edge admin state <module/port> <admin state>
Examples:
set port enable
User level: read-write, admin.
Use the set port enable command to enable a port or a range of ports.
The syntax for this command is:
set port enable [module/port]
module Number of the module (3-6).
port Number of the port on the module. If you do not specify a number,
all the the admin state for all ports on the module is set.
You can also specify a range of ports separated by a dash, for
example, 4/5-13 for ports 5 to 13 on module 4.
admin
state You can set the port admin state to:
• edge-port
• non-edge-port.
C460-1# set port edge admin state 3/1 edge-port
port 3/1 edge admin state is set to edge-port
C460-1# set port edge admin state 3/1 non-edge-port
port 3/1 edge admin state is set to non-edge-port
module Number of the module (3-6).
port Number of the port on the module. If you do not specify a
number, all the ports on the module are enabled.
You can also specify a range of ports separated by a dash, for
example, 4/5-13 for ports 5 to 13 on module 4.