Avaya C460 - Manual (Page 198)

Chapter 2 Avaya C460 CLI Commands
186 Avaya C460 Reference Guide
show outband
User level: read-only, read-write, admin.
Use the show outband command to displays the Ethernet Console port status.
This command applies to the specific supervisor module where you execute it.
The syntax for this command is:
show outband
Example:
show policy type
User level: read-only, read-write, admin.
Use the show policy type command to show whether the module enforces the
active policy-list on all packets or only on routed packets (for modules in 'device-
mode router').
The syntax for this command is:
show policy type
Example:
I/O Module
• Normal
• Not enough power
• Power disabled
• Empty
C460-1> show outband
Status: Connected
Auto-negotiation: Enable
Duplex: Half-Duplex
Speed: 100 MBit/sec
Router-1# show policy type
Policy type is router