Avaya C460 - Manual (Page 209)

Chapter 2 Avaya C460 CLI Commands
Avaya C460 Reference Guide 197
show port redundancy
User level: read-only, read-write, admin.
Use the show port redundancy command to display information about software
port redundancy schemes defined for the switch.
The syntax for this command is:
show port redundancy
Example:
show port trap
User level: read-only, read-write, admin.
Use the show port trap command to display information on SNMP generic
link up/down traps sent for a specific port.
The syntax for this command is:
show port trap [<module>[/<port>]]
Example:
C460-1> show port redundancy
Redundancy Name Primary Port Secondary Port Status
----------------- -------------- ---------------- --------
gregory 3/48 3/47 secondary
amir 3/46 3/45 secondary
lior 3/1 3/2 primary
arie 3/34 3/33 secondary
Minimum Time between Switchovers: 1
Switchback interval: 3
module
(Optional) Number of the module (3-6). If you do not specify a number,
the ports on all the modules are shown.
port
(Optional) Number of the port on the module. If you do not specify a
number, all the ports on the module are shown.
You can also specify a range of ports separated by a dash, for
example, 4/5-13 for ports 5 to 13 on module 4.
C460-1> show port trap 4/1
Port 4/1 up/down trap is disabled